VR6 ‘In House’ Coil Packs
VR6 Performance Ignition Coil Pack Set Up ‘in house’ coils Like MSD Coil Pack.
So here we have set up our ‘in house’ VR6 coil pack, very similar to the MSD coils we also have but the ‘in house’ coils are an unbranded version, originating from the USA from our same supplier of MSD, a slight cost saving but also with the black stealth look which is what we decided on.
To install we just need to retain the base and shroud. The shroud on this coil pack has been ‘chromed’ in the past, still in good condition but even better after a quick polish! To start the original coil pack was dismantled only to find some of the circuit needed was burnt out, so we found another coil pack and dismantled that!
Taking the base and the outer shroud, the rest of the oem coil pack was put to one side, the chromed shroud sandwiched between the custom made bracket and the coil pack base with connector, the coil pack base connector was then attached to the new in house coils using the supplied kit.
Ready to bolt on, here comes a stronger bang supplied from the coils and the future ability to swap out failed coils should they fail!